I don't know if that makes a difference or not. I am also using VSPE to setup pairs to use as comports. I am using DDUtil RCP CAT port to connect to the radio and before anyone asks yes the Output to VAC is enabled. If I configure Skimmer to use SoftRock-IF, Skimmer does not connect to the radio. Hi Darrin, your CW Skimmer setup does not work on my 5000. In Flex changed VAC 1 to enable Direct I/Q and Calibrate I/Q.Īlso tried changing the Flex setting from TS-2000 to PowerSDR If everything looks correct below then it is either DDUtil or VSPE or something else I am not seeing.Īny suggestion would be greatly appreciated.ĬAT = PowerSDR also tried TS-2000 and Kenwoodīaud = 4800 Data Bits = 8 Parity = None Stop Bits = 1 Below is my configuration and it looks very similar to all the other suggestions on the web. I am also using VSPE as the port simulator. I am using a comport that is connected to Skimmer and DDUtil. Skimmer is also saying in the bottom left hand box that the radio is not connected. With Skimmer on I am able to see and decode the messages but the frequency window is blank so I have know idea of were I am located on the band. I even tried the instruction on KE9ES web page. I have followed all the instruction I can find on the web but have not been able to make the two work together. I have read and seen that you can use CW Skimmer with a Flex 5000.
